Adjuster Tool

The standard round shafted Hunter hollowing tool and put an adjustable angle swivel on the end. The angle of the cutter and a short length of shaft (about 5/8″) are adjustable from straight on to a bit less than 90 degrees.

  • The Adjuster tool will allow you to pivot and lock the head in any position from slightly less than 90 degrees left to slightly less than 90 degrees right.
  • The adjustment angle locking screw is the same Torx head size as the cutter mounting screw.
  • The beauty of this adjustable head is you can do nearly everything with one tool.
  • Tools are available with a 12” handle or without a handle.
  • Replacement parts are readily available.  Both Adjuster tools use the # 1 Cutter, # 1 Screw and the # 1 or T-9 Torx Wrench.

The details in sequence to use The Adjuster. 

  1. Start out straight on to create the entrance hole and drill to depth. While straight, do the initial hollowing.  With the cutter straight, it is important to turn the tool to about a 45 degree tilt angle..
  2. As needed, retract the cutter and adjust the angle slightly.
  3. Progressively hollow, adjusting the angle of the head as needed.
  4. Both tools use the same cutter and have the same length of adjustment arm. 
  5. The only difference between the 3/8” shaft and 1/2” shaft is the shaft diameter.   
  6. Like any tool that extends off-axis, care must be taken to avoid catches.
  7. The Adjuster is a finesse tool.  Do not take aggressive cuts.
  8. To avoid chip packing, be sure to blow out chips in the hollow form.
Adjuster Tool
Please see a list of available products below. If you are looking for something specific that you don't see here, please don't hesitate to contact us and we'll be sure to find what you are looking for.